Mountain Models HiperBipe Instruction Manual page 17

1
40. Glue the " Balsa FH8 in place, as shown.
8
1
41. Glue the " Balsa FH5 in place, lined up with
16
the front of FH2 and centered on FH8.
1
42. Glue the " Balsa FH4 parts together, using
16
thin CA.
43. Dry fit FH4 in place on the hatch frame. When
satisfied with the fit, glue it in place with thin CA.
1
44. Glue in place the
place on the hatch, as shown, with thick CA.
45. Glue in place the
the hatch bottom, with thin CA.
46. AFTER COVERING, glue in the
with thick CA.
" Plywood FH10 parts in
16
3 3
" x " magnets, flush with
16 32
3
" Balsa FH4
16
17