Mountain Models HiperBipe Instruction Manual page 41

12. Hinge the Rudder to the
Vertical Fin and the Elevator to the
Stab, using Hinge Tape, as shown
in the drawings. Make sure that
they move freely in each direction.
If they do not, remove the tape and
try again.
13. Install the Control Horns, as
shown, using Thick CA. Trim the
excess tabs sticking out the other
side of the Rudder and Elevator.
Elevator at full
deflection.
14. Press the Motor mount into the
front former, making sure it is
FULLY seated against the former.
Glue it in place with Thin CA.
TAPE
41