Mountain Models HiperBipe Instruction Manual page 36

COVERING:
1. Cover your airplane with SoLite. Do NOT use heavier coverings, such as MonoKote, UltraCote, etc. If
you do, you can warp and damage the structure, and will need a lot of nose weight to balance your
airplane.
2. Refer to the instructions that came with your SoLite on how to cover and in what order to cover your
airplane components.
3. Inspect your wings for any warps. If a wing is warped, remove the warp by twisting it the oposite
direction and heat the covering with your covering iron. Do this a little at a time until the warp is gone.
4. You will open up some areas after you are done covering. These areas include the side windows in the
Fuselage, slots in the fuselage sides for the Horizontal Stab, slots for the Vertical Fin, the servo bays in
the bottom wing,, the areas shown below, and anywhere that parts are being glued together.
36