Mountain Models HiperBipe Instruction Manual page 15

32. Press F19 into place on the
fuselage. Make sure all joints
are fully inserted. Press the back
of the fuselage down so it is
sitting FLAT on the fuselage
bottom and secure the fuselage
top and bottom with thin CA.
3
35. Glue the " balsa H1 and
32
H1a parts together, using thin
CA.
36. Glue H1 onto the H2 parts,
using thick CA, making sure
that it forms to the curve on the
H2 parts.
1
37. Glue the " Ply H3 tabs in
16
place, on H1, as shown below,
using thick CA.
1
33. Glue the " Balsa F17 parts
16
together with thin CA. Slide the
F17 part into the fuselage, by
bending it slightly. Use thick
CA to glue it in place over the
formers.
3
34. Glue the " Balsa F25 in
16
place, as shown, with thick CA.
15