Mountain Models HiperBipe Instruction Manual page 38

4. Assemble the wheels and wheel pants to the
landing gear wire, as shown below. The wire
starts through the wheel pant, through an
spacer, through the wheel, through another
Ply spacer, and out the other side of the wheel
pant.
5. Secure the wheel pant to the landing gear wire
1
with #2 x " screws going through the
4
and into the wheel pant.
6. Glue the landing gear fairings onto the landing
gear wire, as shown below, with Thick CA. You
can cover the wire with a piece of covering or
covering trim.
1
" Lt Ply
8
1
" Lt
8
1
" Ply part
16
38