Mountain Models HiperBipe Instruction Manual page 19

1
50. Glue all " Balsa Stab and Elevator parts
8
together with thin CA, as shown in the images
above.
TOP OF
ELEVATOR
SIDE VIEW OF ELEVATOR
STEEL
RULER
STEEL
RULER
51. Sand all tail parts lightly with 320
Grit sandpaper.
52. Sand a bevel in the elevator and
rudder, as shown. The easiest way to
do this is by placing a metal straight
edge below the part, and one on top
of the part. That way, you don't end
up with a wavy hinge line.
SANDING
BLOCK
TOP VIEW OF RUDDER
19