Mountain Models HiperBipe Instruction Manual page 21

1
59. Glue the " balsa P4 to
16
1
60. Glue the " Plywood P5 through P4 to P3 with thick CA.
16
61. Glue the remaining P2, 2 ea. P7, and P8 together with thick CA, making sure to line up the
edges.
62. Repeat Steps 59 to 61 to make the oposite side. REMEMBER to make a LEFT and RIGHT
wheel pant. Double and tripple check the parts alignment to make sure you do not make 2 of
one side.
3
" Balsa P3, with thick CA.
32
3
58. Glue the " Balsa LG2 to the
32
Balsa LG1 with thick CA, lining up the
edges. Repeat to make a LEFT and
RIGHT side, as shown. Cut out the
center 'tabs' in LG2 so the landing gear
wire can fit in there.
1
"
16
21