GRAPHTEC GL840 User Manual page 137

(2) Set the encryption method.
WEP or WPA-PSK/WPA2-PSK settings can be performed.
When the WIP system is selected, the [WEP] key is displayed.
When the WPA-PS/WPA2-PSK system is selected, the "Password" is displayed. Then, enter in
accordance with the procedure in "(9) Character string entering" described below.
(3) After the encryption method setting in (2) step is completed, the automatic setting (WPS) can be set.
Push button method or PIN method can be selected.
Set the wireless LAN channel to be used from 1ch to 13ch.
(4) Set the stealth.
This is used to set as so to not be able to search the SSID from the other terminal. Enter directly the SSID
name to the device to be connected.
(5) Set the 11n.
When the IEEE802.11n is used, set to "ON".
Select the "Reflection of setting" with the
The "Wireless LAN restarting" message is displayed and the main unit is re-started to reflect the settings.
(5)-5 Other setting
Perform the wireless LAN setting in the other setting.
<Example 1 of operation procedure>
(1) Set to Access point and then restart the wireless LAN. The GL840 is switched to Access point setting
mode.
When the restart is complete, the following MENU display is displayed.
(2) Set the necessary conditions up to the setting.
Access point setting: Set the necessary settings and press the "Apply settings" (
(3) Set the AP-IP in the Other setting and then set the wireless sensor.
The wireless sensor setting cannot be performed when the wireless LAN is disabled.
Make sure that the wireless LAN for the wireless sensor to be connected is enabled by connecting the GS
sensor and terminal/addapter).
key when the above settings are finished.
Device access display
When connecting the child unit to the wireless LAN, the radio
wave strength of the base unit is displayed. When connecting the
child unit to the base unit, the number of the child units (wireless
sensor) connected to this GL840 main unit is displayed.
Wireless sensor display
This is displayed when the GL100-WL (connected
to GS sensor and terminal/addapter) is connected
through the wireless connection.
CHAPTER 3 Settings and Measurement
key).
3-65