GRAPHTEC GL840 User Manual page 131

(4)-5 FTP/WAB server settings
This is used to perform the FTP server setting of backup destination.
Selection item
FTP Client (1) FTP Server
(2) User Name
(3) Password
(4) Port Number
(5) PASV Mode
(6) FTP Server
Connection
Test
FTP server (7) Port number
WEB server (8) WAB number
(4)-6 E-mail settings
Perform the settings to send the e-mail /from the GL840.
The e-mail with the notification setting information (Alarm, Low Battery, Low communication strength, Free
space in SD memory card (only when data capturing) is sent. In addition, when setting to the Periodic
notification, the e-mail will be sent in the set time.
(1) <E-mail send setting>
Selection item
E-mail send setting E-mail
address
setting
Notification
setting
(1) (2) (3) (4) (5) (6)
(7)
(8)
Enter the domain name or IP address of the FTP server. (Up to 127 characters)
Enter the user name of the FTP account. (Up to 31 characters)
Enter the password of the FTP account. (Up to 31 characters)
Enter the port number of a port to be used for FTP. It is normally 21. (0 to 65535)
Make the passive mode setting.
ON : Should be set for communication with an external FTP server in a firewall environment.
OFF : Should be set for communication with an FTP server in a normal network environment.
Press right key to execute (Performs connection test to the FTP server.)
When the connection test is performed, a message is displayed.If connection cannot be
established, check the settings and perform the connection test again.
* If the connection test is passed, the following message is displayed.
Enter the port number used for the FTP. Usually, this number is 80. (65535)
Enter the port number used for the WEB. Usually, this number is 80. (65535)
(1)
(2)
(3)
(4)
TO
CC1 to CC3
Subject
Alarm
Low battery
Low
communication
strength
Free space in SD
memory card
Periodic
notification
Description
Set the e-mail address of the e-mail destination. (Up to 63 characters)
Up to three e-mail addresses can be set as CC (carbon copy). (Up to
63 characters)
The e-mail subject can be registered in the character string entering.
(Up to 63 characters)
When it is set to On, the occurrence of alarm is notified.
When it is set to On, the low battery information is notified.
When it is set to On, the low communication strength information is
notified.
When it is set to On, the SD memory card free space information is
notified.
Set the time to send the notification setting information with the
e-mail to any address.
CHAPTER 3 Settings and Measurement
Description
3-59