GRAPHTEC GL840 User Manual page 136

CHAPTER 3 Settings and Measurement
(5)-3 Other setting
When connecting to the wireless LAN after setting the station, by pressing the [Connect/Disconnect] key, the
"Restart TCP-IP" is displayed and then the connection is established.
To disconnect the wireless LAN during the connection, press the [Connect/Disconnect] key again.
When you want to change the connection conditions, perform the "ST-IP setting".
• When the "IP Addr Auto Acq." is used, select the "On".
• When the "IP Addr Auto Acq." Is not used, select the "Off" and then set the IP address, Subnet masuk, and
Port number, etc.
After the above setting, press the
displayed and the setting operation is completed.
(5)-4 Access point setting
The connection between the GL840 and wireless sensor (GL100-WL) can be performed.
In the access point setting, this function must be set when the GL840 operates as a base unit.
When selecting the wireless LAN as a station and then restarting the wireless LAN, the following screen is
displayed.
Selection item
Access point setting
Other setting
<Operation procedure>
(1) Set the SSID.
Enter in accordance with the procedure in "(9) Character string entering" described below.
By default, the identification name automatically generated from the GL840 name is displayed.
3-64
Key of "Apply settings" in the "ST-IP setting". The "Restart TCP-IP" is
SSD input Set the SSID (access point identification name) of the GL840.
Up to 32 characters of the alphanumeric characters and symbols can be entered.
Automatic setting This function allows you to perform the settings of the connection and security for
(WPS) wireless LAN unit easily.
Select the Push button method / PIN method and then start the WPS automatic
setting
Encryption Perform the encryption setting.
method WEP: Set the WEP key to 10 digits alphanumeric characters and symbols for the
WEP64 and to 26 digits alphanumeric characters for the WEP128.
WPA-PS/WPA2-PSK: Set the password in 8 to 63 alphanumeric characters and
symbols.
WEP key This is displayed when the encryption was set. Perform the key setting.
Channel Perform 1ch to 13ch settings.
Stealth Set the SSID concealment mode.
11n Select whether or not to use the 11ch.
Reflection of Reflect the settings of the encryption method, WEP key, and password.
setting
AP-IP setting Perform the TCP-IP setting.
After setting, restart to reflect the settings.
Wireless sensor Perform the up to 5 wireless sensor settings.
When the wireless sensor is searched and specified, the modules connected to
the wireless sensor are displayed. (AMP1 for one module, AMP1 and AMP2 for two
modules are displayed.) Perform power cycle after operating the OK to change the
wireless sensor settings.
Description