GRAPHTEC GL840 User Manual page 135

Selection item
Station setting Encryption
method
WEP key
11n
Reflection of
setting
Other setting Connect /
disconnect
ST-IP setting
<Operation procedure>
(1) Select the station, and then execute the wireless LAN restart.
The "Wireless LAN restarting" is displayed and the restart is executed by the station setting.
(2) Set the SSID.
Enter in accordance with the procedure of "(9) Character string entering" described below.
Also, to enter the SSID, follow the procedure in "(9) Character string entering". Also, after searching the
SSID in the following (3), you can select it from the list.
(3) Search the SSID.
Press the key. The searched SSID list is displayed after searching the SSID.
In Step (2), when the SSID is selected from this list, the SSID will be automatically reflected.
(4) Set the automatic setting (WPS).
The wireless LAN is automatically set in the WPS system by pressing the
(5) Set the encryption method. (In the case of manual setting)
WEP or WPA-PSK/WPA2-PSK settings can be performed. When this setting is selected, the "WEP key"
is displayed. Enter in accordance with the procedure of "(9) Character string entering" described below.
(6) Set the wireless standard 11n.
When the IEEE802.11n is used, set to "ON".
(7) When the above settings are finished, press the
The settings are saved.
(8) The wireless LAN is enabled by executing the "Connect/Disconnect" in the "Other settings".
Perform the encryption setting.
WEP: Set the WEP key to 10 digits alphanumeric characters and symbols for the
WEP64 and to 26 digits alphanumeric characters for the WEP128.
WPA-PS/WPA2-PSK: Set the password in 8 to 63 alphanumeric characters and
symbols.
This is displayed when the encryption was set. Perform the key setting.
Select whether or not to use the 11ch.
Reflect the settings of the encryption method, WEP key, and password.
Perform the connection or disconnection to/from the base unit.
Perform the IP address automatic acquisition of the station or the IP address manual
setting of the station.
After setting, press the "Apply settings" (
key to execute the "Apply settings".
Effective display
CHAPTER 3 Settings and Measurement
Selection item
Key) to restart. The setting is completed.
key.
3-63