Invacare® Jasmine™
8.8 Replacing the Hanger Bar
This procedure should only be performed by a
qualified technician.
CAUTION!
Risk of Damage
The mounting bracket can become damaged if
hardware is overtightened.
– DO NOT overtighten the nut and screw.
56
1. Remove the side covers A.
Support the hanger bar B from underneath
while removing the attaching hardware.
2. Remove the screw C, washers D, flanged bearings E,
nylon spacers F and nut G that secure the top of the
hanger bar pin H and top rubber cap I to the boom J.
3. Remove the rubber caps K.
4. Remove the socket screw L, washers M, flat washer N
and nut O securing the bottom of the hanger bar pin
to the hanger bar.
5. To install the hanger bar, reverse STEPS 1–4.
1195053-B