Attaching The Battery Charger Mounting Bracket To The Wall - Invacare Jasmine User Manual

4.5 Attaching the Battery Charger Mounting
Bracket to the Wall
Refer to your local regulations concerning proper
mounting procedures.
1. Place the battery charger with mounting bracket A on
the wall at the desired position.
2. With a pencil, mark the middle hole B position.
3. Measure down 6½ inches (16.5 cm) from the pencil
mark and drill one mounting hole.
4. Install bottom mounting screw C until there is an
approximate 1/8-inch (3 mm) gap between screw head
and wall.
5. Install the battery charger with mounting bracket onto
the bottom mounting screw.
6. Drill the remaining two mounting holes.
7. Install the two remaining mounting screws D through
the mounting bracket and into the wall. Tighten
securely.
8. Plug the battery charger into the wall electrical outlet.
LED light indicating ON should illuminate.
1195053-B
Setup
19