Lubricating The Lift; Detecting Wear And Damage; Cleaning The Sling And The Lift; Replacing The Knee Pad - Invacare GET-U-UP LIFT Maintenance Manual

SECTION 8—MAINTENANCE

Lubricating the Lift

A six month check and lubrication should ensure continued safety and reliability of the patient lift.
The casters MUST swivel and roll smoothly. A light grease (waterproof auto lubricant) may be applied to the ball bearing
swivel of the casters once a year. Apply more frequently if the casters are exposed to extreme moist conditions.
Lubricate all pivot points. Wipe all excess lubricant from lift surface.
The connection between the mast and the base should be cleaned and coated with petroleum jelly prior to assembly.

Detecting Wear and Damage

It is important to inspect all stressed parts, such as slings, sling attachment knobs, and any pivot for slings for signs of
cracking, fraying, deformation or deterioration. Replace any defective parts immediately and ensure that the lift is not used
until repairs are made.
All sling metal parts should be inspected every three months and if wear is apparent, replacement must be made.
Check that all labels are present and legible. Replace if necessary.

Cleaning the Sling and the Lift

The sling should be washed regularly in water temperature of 180°F (82°C) and a biological solution. A soft cloth, dampened
with water and a small amount of mild detergent, is all that is needed to clean the lift. The lift can be cleaned with
non‐abrasive cleaners.

Replacing the Knee Pad

NOTE: For this procedure, refer to FIGURE 8.1.
1. Remove the four button screws and washers that secure existing knee pad to the lift.
2. Remove the existing knee pad from the lift.
3. Position the mounting holes in the new knee pad with the mounting holes in the lift.
4. Using the existing hardware, secure the new knee pad to the lift.
Knee Pad
Adjustment Pin
(1 of 2)
™
Get-U-Up Lift
Button Screw
and Washer
(1 of 4)
FIGURE 8.1 Replacing the Knee Pad
26
Part No 1148115