Replacing The Electric Actuator - Invacare Jasmine User Manual

Invacare® Jasmine™

8.5 Replacing the Electric Actuator

This procedure should only be performed by a
qualified technician.
52
Detail A
If possible, use an assistant while removing and
replacing the boom actuator.
WARNING!
Risk of Death, Injury or Damage
During assembly or maintenance of the lift, it
may be necessary to manually raise the boom or
spreader bar.
– Do NOT release the boom or spreader bar
while raising them manually. After assembly
or maintenance is complete, slowly lower the
boom or spreader bar to the original position
before releasing the lift.
– Never manually raise the boom arm while
using the lift.
1. Unplug the boom actuator A from the control box B
on the mast assembly. Thread the actuator lead through
the actuator lead routing hole in the mast assembly.
2. Remove the hardware that secures the top of the boom
actuator to the boom actuator mounting bracket C.
a. Remove the rubber caps D from the top of the
boom actuator.
b. Remove the socket head screw E, washer F, bearing
G, nylon washers H, bushing I, bearing, washer,
flat washer J and locknut K.
Manually lower the boom L carefully to a
resting position after the top of the boom
actuator is removed from the boom actuator
mounting bracket.
1195053-B