Checking The Service Light - Invacare Jasmine User Manual

Invacare® Jasmine™
1. Put the base on a level surface so all casters make
contact with the floor.
2. Press down on the tabs A to lock rear casters B.
3. Unscrew the top knob C and remove it from the base
D.
4. Loosen the bottom knob E, but leave it screwed into
the base.
5. Connect the mast assembly cable (not shown) to the
base cable (not shown).
6. Position the tube of the mast assembly F into the hole
in the base assembly. Make sure not to squeeze the
cables between mast and base.
7. While supporting the mast assembly, tighten the bottom
knob.
8. Screw the top knob into the hole in the base, ensuring
the top knob is tightened.
9. Reverse STEPS 2–8 to disassemble the lift.
WARNING!
Risk of Injury or Damage
To avoid injury or damage from instability of
the mast:
– DO NOT remove the plastic bushing in
the base that surrounds the mast during
disassembly.
18

4.4 Checking the Service Light

Each time the lift is assembled, and before using the
lift, the service light should be checked.
1. Assemble the lift.
2. Examine the control box A or the hand pendant B to
see if the service light C is flashing.
3. Refer to the table.
Service Light Initial Assembly
Flashing Reset the
service light.
Refer to 8.4
Resetting the
Service Light,
page 51.
Not Flashing
N/A
Reassembly
The lift requires
service. Contact
your local
Invacare
dealer or
representative
for service.
The lift is ready
for use
1195053-B