Section 5
This section describes troubleshooting for the D-TEC. Use care to understand and follow all
precautions while troubleshooting the D-TEC.
This section provides troubleshooting information as follows:
Debug Menu (Section 5.1)
No Audible Messages (Section 5.2)
Unable to Override D-TEC (Section 5.3)
5.1 Debug Menu
To debug the D-TEC or check the software versions, hold the Override Switch and toggle the
Up/Down Switch (between Down and neutral). The debug menu is shown on the alphanumeric
display of the Display unit. Each time the Down Switch is toggled, it changes to the next
parameter.
The debug feature may be used to check the current software version of the Display and Sensor
units.
The debug menu parameters are shown as follows:
1. "Debug Menu" Message
2. Display Software Version
3. Date of the Software Version
4. #ORXXXXX where "XXXXX" represents the number of overrides the unit has had
5. #CEXXXXX where "XXXXX" represents the number of Communications Errors the unit
has had
6. Serial Number of the Display
To exit the debug menu, release the Override/Clear and Up/Down Switches.
TP-5522901-00
July 2018
Troubleshooting
'
D-TEC
O
M
PERATOR
S
ANUAL
5-1