Installation Kit (P/N: 5523901); Figure 1-1 Sensor; Table 1-2 Installation Kit - Will Burt D-Tect 5354901 Operator's Manual

1.5.4 Installation Kit (P/N: 5523901)

The Installation Kit (Table 1-2) is used to assist in installation of the system.
P/N Description
3597 Cap Screw ¼-20x4.00 PHIL
PAN HD-SSTL
900711 Electrocution Hazard Warning
Label
5526701 D-TEC Warning Label
911960 D-TEC Override Danger Label
000021-503-501 5 Amp Fuse
901723 Inline Fuse Holder
34061 Cable Tie (Clear)
901765 Cable Tie (Black, UV Rated)
908510 3-Position Toggle Switch
000016-400-101 Keylock Switch Operator
22mm
000013-202-005 4-Pin Plug (MS3106E14S-2S)
000016-300-101 Mushroom Operator 22mm
000016-901-101 Mounting Base with Normally
Opened Contact 22mm
000018-500-001 2 PR D-TEC Custom Cable
000018-520-301 Jacketed 2-Conductor Cable
000023-000-440 Speaker (30 W Compact Horn)
911184 Shipping Carton
915169 Toggle Switch (MS35058-22)
000013-109-003 DB9 Plug with Pigtail
000013-125-002 DB25 Plug with Pigtail
901193 10 Circuit Terminal Block
D-TEC Operator's Manual
TP-5522901
WD-5354501 D-TEC Wiring Diagram
TP-5522901-00
July 2018

Table 1-2 Installation Kit

Qty Usage
4 Mounting Screws
1 Provides warning about electrocution
hazards.
1 Provides general safety precautions.
1 Provides overriding warning.
1 Installed inline with power supply.
1 Installed inline with power supply.
20 Used to secure cables inside the vehicle.
80 UV rated cable ties are used to secure
cables outside the vehicle.
1 Used to operate the mast.
1 Used to override alarms.
1 Connects 2 PR D-TEC Custom Cable to
Sensor.
1 Used to clear and override alarms.
2
150 ft. Connects to the Sensor.
100 ft. Connects to Speaker.
1 Used to announce alarms
1 Packaging
1 Power Switch
1 Connects to J3 on the Display.
1 Connects to J6 on the Display.
3 Used to assist in electronically
connecting D-TEC components.
1 Provides general information on the
operation of the D-TEC.
1 Provides information on system wiring.
'
D-TEC O M
PERATOR S ANUAL
1-7