Unpack The D-Tec; Install The Sensor; Figure 2-7 Mount Sensor To Installation Bracket - Will Burt D-Tect 5354901 Operator's Manual

'
D-TEC O M
PERATOR S

2.5.2.2 Unpack the D-TEC

Unpack the D-TEC as follows:
1. Carefully open and remove all parts from the shipping container.
2. Inspect for any shipping damage. Notify the carrier if damage is evident.
3. Ensure all components are included and that the tools are readily available.

2.5.2.3 Install the Sensor

These instructions assume the use of the Installation Bracket. As the size and shape of the
antennae will vary, the customer is responsible for modifying the Installation Bracket to position
the Sensor appropriately above the antenna.
To install the Sensor:
1. Keeping in mind the information on mounting location and orientation discussed in
Section 2.5.2.1, mount the Sensor on the Installation Bracket using the four M6 screws
and M6 lock washers located on the bottom of the Sensor (Figure 2-7). The mounting
hardware must include a proper means to resist vibration loosening such as thread-
locking compound or locking hardware. Torque to 60-72 in.-lb. (6.8-8.1 N-m).
Note: Will-Burt provided hardware assumes the mounting surface is ¼ inch (6 mm) thick.
If the mounting surface is thicker than this distance, the customer will need to supply
longer M6x1 screws.
Will-Burt Provided Hardware (Two Sets Hidden)
Sensor Front View
Sensor Bottom View
2-12
ANUAL
Will-Burt Provided

Figure 2-7 Mount Sensor to Installation Bracket

Will-Burt Provided
Hardware
(Two Sets Hidden)
Hardware
Sensor Attached to Installation Bracket
TP-5522901-00
July 2018