Figure 2-9 Wall Mount Display Mounting Hole Locations - Will Burt D-Tect 5354901 Operator's Manual

'
D-TEC O M
PERATOR S
Wall Mount Display Installation
The Will-Burt provided hardware assumes the mounting surface is ¼ inch (6 mm) thick. If the
mounting surface is thicker than this distance, the customer will need to supply longer M6x1
screws. Screws should be sized to length to allow for the thickness of the mounting surface, the
Wall Mount Display, and all mounting hardware (e.g. flat washers, lock washers, and nuts).
To install the Wall Mount Display:
1. Use either the installation dimensions for the Display (Section 2.4.3), or the Wall Mount
Display itself as a template to mark the mounting holes locations (Figure 2-9).
Mounting
Holes
2. Drill the mounting holes.
3. Position the Wall Mount Display and secure it in position. The mounting hardware must
include a proper means to resist vibration loosening such as thread-locking compound or
locking hardware. Torque all hardware as appropriate for its size and grade.
2-14
ANUAL

Figure 2-9 Wall Mount Display Mounting Hole Locations

Mounting
Holes
TP-5522901-00
July 2018