Table of Contents
Advertisement
Section 2
This section describes installation of the D-TEC and provides general procedures that must be
followed to ensure a successful installation. Use care to understand and follow all precautions
while installing.
2.1 Pre-Installation Check
Before installing the system, ensure:
All installers read and understand the entire installation procedure
All components are included (Section 1.5)
All required equipment is readily available (Section 2.2)
The mounting structure is level with sufficient room to mount the system (Section 2.4)
When installing on a vehicle, that the vehicle is stationary
That the following precautions are understood and followed:
Safety Instruction – Operation! Before beginning operation, make certain that the area is free
of overhead power lines and other unwanted sources of electricity. Follow OSHA safety
regulations when working near energized power lines. Your attention is directed to the OSHA
electrical safety requirements in 29 C.F.R. part 1910. Be sure to allow sufficient clearance on all
sides of mast to allow for side sway.
Safety Instruction – Trained Personnel Only! Only trained and qualified personnel should
perform installation, adjustments, and servicing. Only a properly trained and qualified certified
electrician should perform electric installations and service.
Electrocution Hazard! Do not touch live wires. Death or serious injury could result.
Lifting Hazard! The mast is intended to lift a specific payload for lighting, surveillance or
communication use only. Any other use without written consent is prohibited and could cause
death or serious injury. Do not use mast to lift personnel. Do not exceed specified payload
capacity.
Safety Instruction – Roof Access! If mast will be mounted to a vehicle, the operator must
provide safe means to access the roof of the vehicle during installation and maintenance.
TP-5522901-00
July 2018
Installation
'
D-TEC
O
M
PERATOR
S
ANUAL
2-1
Advertisement
Table of Contents
