Spare Parts; Scheduled Maintenance; Table 4-2 Preventative Maintenance Schedule - Will Burt D-Tect 5354901 Operator's Manual

'
D-TEC O M
PERATOR S

4.3 Spare Parts

To order spare or replacement parts, always refer to the D-TEC model number and serial
number. These can be located on the Sensor. Throughout this manual, "P/N" followed by a
number represents the part number for that component.

4.4 Scheduled Maintenance

Table 4-2 provides a schedule of preventative maintenance inspections and procedures to keep
the D-TEC in good operating condition.
Frequency Inspection
Before Each Inspect the lens of the Look-Up Light
Deployment to ensure it is clean.
Before Each Inspect for damage before use.
Deployment
Monthly Inspect all connectors and wires to
ensure they are firmly attached and
properly seated.
Monthly Inspect all external fasteners. Look
for loose, missing, bent, or broken
fasteners. Pay particular attention to
the fasteners securing the D-TEC to
the Installation Bracket and the
Installation Bracket to the antenna
fixture.
Semi- Inspect the lens of the Look-Up Light. Clean with warm soapy water and a
Annually
4-2
ANUAL

Table 4-2 Preventative Maintenance Schedule

Action
If necessary, clean with warm soapy
water and a soft cotton cloth.
If damage is apparent, do not use the
system and have it serviced before
use.
If necessary, re-secure connectors
and wires.
Replace any missing or damage
hardware. If any hardware is found
loose, retighten.
soft cotton cloth.
TP-5522901-00
July 2018