Table of Contents
Advertisement
2.6.2.5 Install Speaker
The 8 ohm speaker (P/N: 000023-000-440) is used to announce alarms. The operator should
use the provided 100 ft. (30.5 meter) 2-conductor cable (P/N: 000018-520-301) when installing
the speaker.
To install the speaker:
1. Mount the U-shaped bracket.
2. Connect the speaker to the U-shaped bracket.
3. Secure the cables from the speaker to the provided 100 ft. (30.5 meter) 2-conductor
cable (P/N: 000018-520-301).
4. Run the cable from the speaker to the DB25 Terminal Block. Cable ties have been
provided to assist in securing the cable in place. The black Cable Ties are UV rated for
outside use. The clear Cable Ties are for inside the vehicle. If necessary, cut off the
extra cable, being sure to leave enough to allow the cable to attach to the DB25
Terminal Block.
5. Secure the:
a. Negative cable from the speaker to the DB25 Terminal Block where the black
wire from DB25-23 connects.
b. Positive cable from the speaker to the DB25 Terminal Block where the red wire
from DB25-10 connects.
Note: If desired, an optional second speaker (customer-supplied) may be added (Figure 2-16).
TP-5522901-00
July 2018
Figure 2-16 Install the Speaker
'
D-TEC
O
M
PERATOR
S
ANUAL
2-21
Advertisement
Table of Contents
