Finalize Installation; Test The Installation; Figure 2-27 Warning Labels (Not To Scale) - Will Burt D-Tect 5354901 Operator's Manual

2.6.2.13 Finalize Installation

To finalize installation:
1. As necessary, secure the Terminal Blocks and cables. Cable ties have been provided to
assist in securing the cables in place. The black Cable Ties are UV rated for outside use.
The clear Cable Ties are for inside the vehicle.
2. Apply the warning labels from the Installation Kit where the operator will have a clear
view of them while operating the D-TEC (Figure 2-27).
Electrocution Hazard Warning
(P/N: 900711)

2.7 Test the Installation

This section describes testing the installation of the D-TEC. Use care to understand and follow
all precautions while testing. Before testing the installation, ensure:

The Sensor is properly positioned and secured

The Display is properly positioned and secured

All required electrical connections have been made and are secure including the
connection to the Sensor
The following test should be completed after installation of the D-TEC. The unit should meet all
of the below criterion before use in the field. To test the installation:
1. Turn on the Display. When power is applied to the Display, a self-test is performed, and
the audible message "Running Diagnostics" will be heard on the speaker and the text
message "Self Tst" will be displayed. When testing has been successfully completed, the
system ready LED (green) will come on, a "MAST ENA" message will be displayed, and
the audible message "D-TEC Active" will be heard on the speaker.
2. Check the green System Ready LED on the Display to ensure it is steady. When the
LED is lit for:

Pneumatic mast, the Air Control Valve will be enabled and the mast controls will
be operational

Mechanical masts, the mast controls will be operational
TP-5522901-00
July 2018
D-TEC Warning Label
(P/N: 5526701)

Figure 2-27 Warning Labels (Not to Scale)

'
D-TEC O M
PERATOR S
D-TEC Override Danger Label
(P/N: 911960)
ANUAL
2-29