Installation Hardware; Table 2-2 Installation Hardware - Will Burt D-Tect 5354901 Operator's Manual

2.3 Installation Hardware

Table 2-2 describes hardware that may be used during installation. Depending on the specific
installation application, all hardware may not be used.
Hardware*
Sensor (P/N: 5354901) to Installation Bracket
(4) M6-1x22 mm Screws
(4) M6 Lock Washers
Installation Bracket (P/N: 5524101) to Mounting Structure
(6) ⅜ inch or M8 Screws
Rack Mount Display (P/N: 5354801) to Mounting Structure (For Rack Mount Kits only)
(4) 0.281 inch (7.1 mm) slots
have been provided to assist
in securing the Rack Mount
Display to the Rack Mount.
Wall Mount Display (P/N: 5354701) to Mounting Structure (For Wall Mount Kits only)
(4) M6-1x100mm Socket
Head Cap Screws
(4) M6 Flat Washers
* Unless otherwise indicated, the mounting hardware must include proper means to resist vibration loosening such
as thread-locking compound or locking hardware. Torque all hardware as appropriate for its size and grade.
Torque values in these instructions assume the use of Will-Burt provided hardware. Depending on the specific
installation application, all hardware may not be used. Additional hardware may be required for additional
accessories, or customer-specific applications.
TP-5522901-00
July 2018

Table 2-2 Installation Hardware

Supplied By Notes
Will-Burt Ships attached to the Bottom of the Sensor.
Note: Will-Burt provided hardware assumes the
mounting surface is ¼ inch (6 mm) thick. If the
mounting surface is thicker than this distance, the
customer will need to supply longer M6x1 screws.
Screws should be sized to length to allow for the
thickness of the mounting surface, the Wall Mount
Display, and all mounting hardware (e.g. flat
washers, lock washers, and nuts).
Will-Burt Ships attached to the Bottom of the Sensor.
Customer Screws should be sized to length to allow for the
thickness of the mounting brackets, mounting
surface, and all mounting hardware (e.g. flat
washers, lock washers, and nuts).
Customer Screws should be sized to length to allow for the
thickness of the Rack Mount Display, rack mount,
and all mounting hardware (e.g. flat washers, lock
washers, and nuts).
Will-Burt Ships with Wall Mount Display.
Note: Will-Burt provided hardware assumes the
mounting surface is ¼ inch (6 mm) thick. If the
mounting surface is thicker than this distance, the
customer will need to supply longer M6x1 screws.
Screws should be sized to length to allow for the
thickness of the mounting surface, the Wall Mount
Display, and all mounting hardware (e.g. flat
washers, lock washers, and nuts).
Will-Burt Ships with Wall Mount Display.
'
D-TEC O M
PERATOR S ANUAL
2-3