Xinje DS2-20P2-AS User Manual page 35

 U-21 displays I/O signals status
The following diagram describes the input and output signals status displayed in U-21.
Diagram 1
In diagram 1, LED4 and LED5 stand for input signals status, and LED1 and LED2 stand
for output signals status. In diagram 2 there shows the segment No. of each LED.
 Input signals status
Segment Description
LED4_0 /SPD-A internal set speed selection
LED4_1 /SPD-B internal set speed selection
LED4_2 /C-SEL control mode selection
LED4_3 /ZCLAMP zero clamp
LED4_4 /INHIBIT prohibit pulse command
LED4_5 /G-SEL switch the gain
LED4_6 /CLR clear the pulse
LED4_7 /CHGSTP change the step
 Output signals status
Segment Description
LED1_0 /NEAR near
LED1_1 /ALM alarm output
LED1_2 /Z encoder Z phase output
 U-22 displays I/O terminals status
The following diagram describes the input and output terminals status:
Diagram 1
In diagram 1, LED5 stands for input signals status, and LED2 stands for output signals
status. In diagram 2 there shows the segment No. of each LED.
Input terminals
Segment Description
LED5_0 Input status of SI1
LED5_1 Input status of SI2
LED5_2 Input status of SI3
LED5_3 Input status of SI4
LED5_4 Input status of SI5
Diagram 2
Segment
LED5_0
LED5_1
LED5_2
LED5_3
LED5_4
LED5_5
LED5_6
LED5_7
Segment
LED2_0
LED2_1
LED2_2
LED2_3
LED2_4
LED2_5
LED2_6
LED2_7
Diagram 2
Segment
LED2_0
LED2_1
LED2_2
Description
/S-ON servo signal
/P-CON proportion action command
/P-OT forward prohibit
/N-OT reverse prohibit
/ALM-RST clear the alarm
/P-CL external torque limit at
forward side
/N-CL external torque limit at
reverse side
/SPD-D internal set speed selection
Description
/COIN positioning completed
/V-CMP speed synchronization
checking
/TGON rotate checking
/S-RDY ready
/CLT torque limit
/VLT speed limit checking
/BK brake lock
/WARN warn
Output terminals
Description
Output status of SO1
Output status of SO2
Output status of SO3
27