FP POSTBASE ONE Operator's Manual page 157

Remove housing connector
Housing connector
Remove the protective glass from the postage meter
Transport bar
Appendix – Moving the PostBase One to another location
The connectors for mechanic coupling of the
housings are located in the clearances of the
side walls.
To remove the connectors:
• Slightly lift the affected component and
remove the connector to the bottom.
When using the original packaging for trans-
port, you have to remove the protective
glass.
The protective glass is fastened to the hous-
ing of the postage meter with four screws.
• Remove the four screws.
• Remove the protective glass.
• Fasten the transport bar (part of the origi-
nal packaging) to the housing of the post-
age meter with the four screws.
157