FP POSTBASE ONE Operator's Manual page 134

134
PostBase One Mailing System
Issue
...
with automatic feeding
Feeding deforms or damages
letters.
Jam.
Letters are not correctly sepa-
rated.
Letter transport
does not start.
Letter transport is stopped /
batch processing was inter-
rupted.
Separation error, letter interval
too close.
Possible cause and remedy
Reduce separation (see chapter 3.5.2.3, page 19).
Notice the suggested settings for separation
(see table on page 17).
Check setting of letter path (slide control) and
adjust accordingly (see chapter 3.5.1, page 16).
Check and adjust settings for separation (see
chapter 3.5.2, page 17).
On how to clear a letter jam, please read
chapter 13.3, page 137 and chapter 13.4, page 138.
Check setting of letter path (slide control) and
adjust accordingly (see chapter 3.5.1, page 16).
PostBase One does not display the Home screen /
the 'Batch Processing' pop-up.
Sensor does not recognize the letters.
To start letter transport: In the 'Batch Processing'
pop-up, press the S
Feeder cover is open. Re-place cover correctly on
the feeder. The cover must latch audibly (see page 19).
Jam. Carefully read the displayed information.
On how to clear a letter jam, please read
chapter 13.3, page 137 and chapter 13.4, page 138.
The batch counter is turned on. After the pre-set
number of mail pieces have been processed,
PostBase One will automatically stop.
Disable the batch counter or adjust the target count
(see chapter 5.3.2.3, page 53).
Reduce pressure (see chapter 3.5.2.2, page 18).
Notice the suggested settings for separation
(see table on page 17).
button.
TART