Printronix T6000 Reference Manual page 60

No communication between the
printer and the RFID encoder
Tag failed
Inconsistent results
The RFID encoder works, but it
does not meet expectations
The RFID icon is greyed out in the
Settings section:
60
Symptom Solution
1. Make sure the reader is enabled via Control >
RFID Active menu (page 16).
2. Use the Diagnostics > Read Tag feature
(page 24) to read and display the current RFID
tag content.
3. If the problem persists, your RFID encoder
may be disconnected or defective. Contact
your authorized service representative.
1. The label could be misaligned. Perform the
Sensors > Control > Auto Calibrate procedure
to ensure the label is at top-of-form. For more
information, refer to the Administrator's
Manual.
2. Make sure the media are smart labels with
RFID tags located in the correct position.
3. The RFID tag could be defective. Try another
tag.
4. Make sure the application does not send too
few or too many digits to the RFID tag.
Make sure the media is loaded correctly. For more
information, refer to the Administrator's Manual.
Make sure that both Control > Error Handling and
Control > Label Retry are set to desired values.
The printer did not detect the RFID encoder at
power-up. Your RFID encoder may be discon-
nected or defective. Contact your authorized ser-
vice representative.