Tag Type; Error Handling; Label Retry - Printronix T6000 Reference Manual

Tag Type

This menu item selects the tag type in use. Other types may be added in the
future. See section Website Support on page 9 to view a current list on the
website.
Alien
Sqlet
S/Trac Web M5
Factory Default

Error Handling

This menu item selects the error handling mode for RFID failures.
Overstrike
None
Stop
Factory Default

Label Retry

This menu item selects the number of label retries that the RFID encoder will
attempt before declaring a fault. This may indicate a problem with the RFID
encoder, the coupler assembly, the printer setup, or the label stock.
Minimum
Maximum
Factory Default
IMPORTANT
RFID > Control > Tag Type
®
9740
See section Supported UHF Gen2 Tag Types on page
11 for lists of supported tag types in the order they
...
appear in the menu (alphabetical order).
Set Automatically
RFID > Control > Error Handling
Each failed label prints with the Overstrike pattern and
the form retries on a new label until the Label Retry
count is exhausted. Whether or not an error message
will display or the failed label will reprint depends upon
the Max Retry Error setting.
No specific action is taken when a tag fails to be pro-
grammed.
The printer will halt and display the error message
"RFID Error: Check Media." The label is discarded and
reprinting of the label (if desired) must be initiated from
the host. When the error is cleared, the label with the
failed tag moves forward until the next label is in posi-
tion to be printed.
Overstrike
RFID > Control > Label Retry
1
10
10
Label Retry only applies when the Error Handling mode
is set to Overstrike.
17