Servo Set; Servo Set Detail - GRAUPNER mz-32 HoTT Reference Manual

Graupner mz-32 Help Reference Manual
Telemetry Speed
In those situations where, for example, two airplane models are about to be operated at
close proximity to another controlled by two separate transmitters, you may choose to
reduce or eliminate the telemetry back channel of one of the models to avoid potential
interference. Situations that may need to be evaluated include drones that have a separate
transmitter for control and camera operations, or airplanes that tow or carry other
airplanes, can be all pick up interference from the telemetry downlink transmission.
Experiment with the proper telemetry period value for your situation.
You can reduce the amount of telemetry data transmitted back from the receiver to the
radio as follows:
 Always: Transmits telemetry data with each data packet.
 4 Times: Transmits telemetry data each 40ms
 8 Times: Transmits telemetry data each 80ms
 Off: No telemetry data is transmitted.
B03S1
The Direction field enables you to reverse the channel direction.
Tapping on the Detail icon lets you fine tune servo parameters.
The Trim field is your sub trim value for centering your servo or control surfaces.
The Travel and Limit fields let you adjust servo throws and maximal servo deflection. Set
the deflection to a value where the servo does not mechanically bind.
The value in the Delay fields will determine the speed of the control movement.
All settings in the Servo Set menu are applied globally and are not Phase dependent.
Trim: your sub trim for centering your servo or control surfaces.
Travel: sets the desired travel range for your servo.

SERVO SET

Please be careful when making changes to the throttle
direction as it may unexpectedly start the motor.
Always ensure that the propeller or main battery are
disconnected.
In the Servo Set menu you can make all basic
adjustments to your servos to optimally tune them to
your model.
The first two columns show the channel number and
channel name. Tapping on the channel number or
name shows the edit bar where you can name or
rename your channel name. Choose a proper channel
name that will help you identify each channel function.

SERVO SET DETAIL

The Servo Set Detail menu enables you to fine tune
your servo settings.
Balance: Here you can adjust the servo travel to ensure
that each control surface is moving in an identical way.
To make changes to a curve point, move the control
over the point to select or by tapping on the input field
under the balance column.
When a curve point is selected, it will turn orange. Now
you can either move the curve point using the arrow
keys or with the orange slider tab along the vertical
axis.
Page 9 of 42 Help-Ref-EN-V1.0