Table 6-3: Dpx Measurement Processing Characteristics - Tektronix H600 RFHawk Service Manual

H600 & SA2600 Service Manual
Table 6-2: Spectrum analyzer characteristics (cont.)
Characteristic Description
Spectral Display Amplitude
Reference Range: +20 dBm to –160 dBm
Level Range
Units: dBm, dBmV, dBuV, dBV, dBW, V, W
and Units
Marker ±1.75 dB, –50 dBm ≤ input ≤ +20 dBm, preamp off
Power
±3.0 dB, –80 dBm ≤ input < –50 dBm, preamp on, above 10 MHz
Accuracy
±3.75 dB, –120 dBm ≤ input < –80 dBm, preamp on, above 10 MHz
Use peak detector for CW signals
Accuracy guaranteed for CW signals and span set to 20 MHz or less
Display
Display Normal - updates display with each new result
Modes Max Hold - updates displayed point only if new point > old
Min Hold - updates displayed point only if new point < old
Max/Min Hold - displays a vertical bar between Max Hold and Min Hold
Average - displays average of N (specified by user) acquisitions
Average is calculated as follows:
Last N values are saved in memory; when a new result is available,
the earliest result of the N stored values is discarded, the new result
is added to the stored values, and a new average is calculated from
the stored values
If the number of results is less than N, then all of the results are
averaged together
Number of 1 ≤ N ≤ 200
Averages

Table 6-3: DPX measurement processing characteristics

Characteristic Description
Spectrum H600 (or SA2600 with Option EP1): 10,000 per second (span
Processing Rate, independent)
Typical SA2600: 2,500 per second (span independent)
Minimum Signal H600 (or SA2600 with Option EP1): 125 μs
Duration for 100%
SA2600: 500 μs
Probability of
Intercept, Typical
5 kHz to 20 MHz
Span Range
RBW Settings RBW = Span/200
Specifications
6–5