Removal and Replacement Procedures
Removal and Replacement Procedures
Preparation
Equipment Required
4–2
This subsection contains procedures for the removal and replacement of all
replaceable mechanical and electrical modules.
NOTE.
The instrument does not require calibration after removal and replacement
of the indicated parts.
WARNING.
Before doing this or any other procedure in this manual, read the
Safety Summary found at the beginning of this manual. Also, to prevent possible
damage to the instrument components, read Preventing ESD in this section. (See
page 4-3.)
This subsection contains the following items:
This preparatory information that you need to properly do the procedures
that follow.
List of tools required to remove and disassemble all modules.
Procedures for removal and reinstallation of the electrical and mechanical
modules.
CAUTION.
Disconnect the power adapter and remove all batteries from the
instrument before disassembling the instrument.
Table 4-1: Tools required
Item
no.
Name
1.
Screwdriver handle
2.
T-9 Torx tip
3.
T-10 Torx tip
4.
T-15 Torx tip
5.
P0 Pozi tip
Description
Accepts Torx-driver and
Pozi bits
Used for removing
instrument screws
Used for removing
instrument screws
Used for removing
instrument screws
Used for removing
instrument screws
H600 & SA2600 Service Manual
General Tool number
620-440
640-234
640-235
640-247
640-234