H600 And Sa2600 Instrument-Specific Battery Maintenance - Tektronix H600 RFHawk Service Manual

Spectrum analyzer
Table of Contents

Advertisement

Lithium-Ion Battery Maintenance
Transportation
Disposal and Recycling
H600 and SA2600 Instrument-Specific Battery Maintenance
Instrument Run Time
4–26
Keep the battery away from children.
Do not use a damaged battery.
If a battery pack is leaking fluids, do not touch any fluids. Properly dispose of
a leaking battery pack (see Disposal and Recycling in this document).
WARNING.
In case of eye contact with battery fluids, do not rub eyes. Immediately
flush eyes thoroughly with water for at least 15 minutes, lifting upper and lower
lids, until no evidence of the fluid remains. Seek medical attention.
Always check all applicable local, national, and international regulations
before transporting a Lithium-Ion battery.
Transporting an end-of-life, damaged, or recalled battery may, in certain
cases, be specifically limited or prohibited.
Lithium-Ion batteries are subject to disposal and recycling regulations that
vary by country and region. Always check and follow your applicable
regulations before disposing of any battery. Contact Rechargeable Battery
Recycling Corporation (www.rbrc.org) for U.S.A. and Canada, or your local
battery recycling organization.
Many countries prohibit the disposal of waste electronic equipment in
standard waste receptacles.
Place only discharged batteries in a battery collection container. Use electrical
tape or other approved covering over the battery connection points to prevent
short circuits.
The instrument run time depends on power consumption, which in turn depends
on the instrument measurement mode. For example, DPX™ Spectrum Display,
Spectrum analyzer, and audio demodulation measurements consume more power
than other measurements because they are continuously acquiring data.
With two new, fully charged batteries, you can run the DPX Spectrum
Display measurement for approximately four hours, or the Spectrum analyzer
measurement for five to six hours. Both of these run times are with the instrument
power management mode disabled. Enabling instrument power management
increases the instrument run time.
H600 & SA2600 Service Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sa2600

Table of Contents