Number Of Samples To Average - Omron ZX-LDA11 Operation Manuals

Through-beam Sensor Heads: FUN Mode Functions
Display value
(mm)
3-8-3

Number of Samples to Average

The number of samples to average is the number of data points used to
average data measured by the Sensor.
Increase the number of samples to average to decrease variations in order
to achieve fine positioning and judgement. If the number of samples is
increased, however, the response time of the judgement outputs and linear
output will be increased.
The following table shows the relationship between the number of samples
to average and the response time.
Number of samples to average
Number of Samples to Average and Response Time
Note: When the number of samples to average is increased n times, the resolu-
tion is generally improved
50.0
5.0
5.0
1
2
4
8
16
32
64
128
256
512
1,024
2,048
4,096
n
Refer to 4-5-12 Other Special FUN Mode Settings.
Display value
Actual value measured
Actual incident beam width (mm)
Response time (ms)
times.
Section 3-8
0.3
0.5
0.8
1.5
2.5
5
10
20
40
75
150
300
600
87