Inputting Threshold Values Directly - Omron ZX-LDA11 Operation Manuals

T (Threshold) Mode
4-4-2

Inputting Threshold Values Directly

The threshold values can be input directly without using the teaching func-
tion. Threshold values can also be fine-tuned after teaching. The mea-
sured value is displayed on the main display and the threshold value is
displayed on the sub-display.
Changing the Numeric Value
Press the UP, DOWN,
RIGHT, or LEFT Key.
The digit
being set
flashes.
Decrements the
numeric value.
122
Moves to a
higher digit.
Set the mode switch to T.
RUN T
Select the threshold value that is to be
input directly using the threshold switch.
H
Press the UP, DOWN, RIGHT, or LEFT
Key.
Direct input will be started.
The leftmost digit of the threshold value
will flash on the sub-display.
Change the numeric value using the
procedure shown in the following figure.
Moves to a
lower digit.
Section 4-4
FUN
L
Increments the
numeric value.