Table of Contents
Advertisement
SUPERSERVER 6027PR-HC1(R/TR/FR) USER'S MANUAL
6-10 Expansion Slot Setup
Each node drawer includes a slot for one low profile, half length PCI-Express
expansion card, a total of four in the system.
Installing Expansion Cards (Figure 6-12)
1. Power down the node and remove the drawer.
2. Remove the riser card and riser card bracket from the drawer.
3. Pull open the PCI slot clip in the rear of the drawer.
4. Slide the temporary PCI slot shield toward the slot clip and remove it from the
drawer chassis.
5. Insert the expansion card to the riser card expansion slot.
6. Insert the riser card into the serverboard expansion slot while positioning the
bracket in the drawer and the expansion card shield in the PCI slot of the
drawer chassis.
7. Secure the expansion card bracket to the drawer chassis and attach the PCI
slot clip in the rear of the drawer.
The riser card and riser card bracket are not normally separated.
Riser Card
Bracket
Screws
Figure 6-12. Installing the Low Profile Expansion Card
Expansion Card
PCI Slot
Shield
6-14
Riser Card
on Bracket
Advertisement
Table of Contents
