Expansion Card/Pci Slot Setup; Installing The Riser Card - Supero SUPERSERVER 2027TR-HTQRF User Manual

Expansion Card/PCI Slot Setup

The SC217 chassis supports one low-profi le expansion PCI slot for each node, for
a total of four PCI slots in the chassis. To install a low-profi le PCI card, follow the
following instructions.

Installing the Riser Card

Installing the Riser Card (Figure 6-14)
1. Disconnect the chassis from any power source and lay the chassis on a fl at
surface.
2. Pull the motherboard node drawer from the chassis.
3. Remove the expansion card bracket.
3a. Remove the screw securing the expansion bracket to the back of the
drawer.
3b. Lift the bracket out of the motherboard node drawer.
4. Align the riser card mounting hole to the bracket standoff and secure the riser
card to the bracket using the two screws included in the accessory box.
5. Inser the riser card along with the riser bracket into the motherboard.
6. Secure the riser bracket to the motherboard node drawer's rear window.
Figure 6-14: Installing the Riser Card
6-15
Chapter 6: Advanced Chassis Setup