Table of Contents
Advertisement
SUPERSERVER 6027PR-HC1(R/TR/FR) USER'S MANUAL
5-2
Connecting Cables
Now that the processors are installed, the next step is to connect the cables to
the serverboard.
Connecting Data Cables
The cables used to transfer data from the peripheral devices have been carefully
routed in preconfigured systems to prevent them from blocking the flow of cooling
air that moves through the system from front to back. If you need to disconnect
any of these cables, you should take care to reroute them as they were originally
after reconnecting them (make sure the red wires connect to the pin 1 locations). If
you are configuring the system, keep the airflow in mind when routing the cables.
5-3
Rear I/O Ports
3
5
1
4
2
Back Panel I/O Port Locations and Definitions
1
2
3
4
5
6
7
8
9
6
7
Backplane USB0
Backplane USB1
IPMI LAN
Gigabit LAN1 (for X9DRT-P/X9DRT-PIBF), 10G LAN (for X9DRT-PT)
Gigabit LAN2 (for X9DRT-P/X9DRT-PIBF), 10G LAN (for X9DRT-PT)
InfiniBand (IB) Connector (for X9DRT-PIBF)
VGA (Blue)
UID LED (on the serverboard)
UID Switch
Figure 5-1. Rear I/O Ports
5-2
8
9
Advertisement
Table of Contents
