Table of Contents
Advertisement
Expansion Card/PCI Slot Setup
The SC217HQ+ chassis supports one low-profile expansion PCI slot for each node,
for a total of four PCI slots in the chassis. To install a low-profile PCI card, follow
the following instructions.
Installing the Riser Card
Installing the Riser Card (Figure 6-13)
1. Disconnect the chassis from any power source and lay the chassis on a flat
surface.
2. Pull the serverboard node drawer from the chassis.
3. Remove the expansion card bracket.
3a. Remove the screw securing the expansion bracket to the back of the
drawer.
3b. Lift the bracket out of the serverboard node drawer.
4. Align the riser card mounting hole to the bracket standoff and secure the riser
card to the bracket using the two screws included in the accessory box.
5. Inser the riser card along with the riser bracket into the serverboard.
6. Secure the riser bracket to the serverboard node drawer's rear window.
Figure 6-13. Installing the Riser Card
6-15
Chapter 6: Advanced Chassis Setup
Advertisement
Table of Contents
