Honeywell 6820EVS Installation And Optimization Manual page 247

Operation
Gain EVS Control at an LOC
Gain EVS Control as EVS Super
User at an LOC (only one EVS
Super User is allowed EVS Control
in the system at a time).
Select all output group for
microphone override
Select all non-activated output
groups for microphone override
How to Operate the Microphone:
1. Press the EVS Control button
2. Key the Microphone
3. Press the All Call button
How to Reset the EVS System
1. Press the Reset button
2. Select 2 to Reset emergency system
EVS-LOC Operating Instruction
For Live Message
1. Key the Microphone.
2. Press the All Call Key or select desired output area using select keys.
3. Deliver your verbal message.
For Pre-recorded Message
1. Select desired EVS Message Key 1-8.
• If EVS Control LED is on steady, the LOC has EVS Control.
• If EVS Control LED is Blinking, another LOC has EVS Control.
Table 2: EVS Control Request
Press the EVS Control Key and enter a code if prompted. If EVS Control is
available, the EVS Control LED will illuminate. If another LOC has EVS
Control, the display will be similar to the one shown. Press 1 to request control.
The LOC with EVS Control will then be able to allow or deny the request.
From the idle screen, enter an EVS Super User access code and then press
the EVS Control Key. If EVS Control as Super User is available, the EVS
Control LED will illuminate. If another LOC has Super User EVS Control, a
request for Super User EVS Control will automatically be made to the LOC
with control. The LOC with Super User EVS Control will then be able to allow
or deny the request. (See Figure 1-2 for screen display example).
Key the microphone, press the All Call Key, wait for the Ready-to-Talk LED to
light, and then deliver your verbal message.
Key the microphone, press the Non-Active Call Key, wait for the Ready-to-Talk
LED to light, and then deliver your verbal message.
Task
P/N: LS10161-001SK-E Rev A
ECN: 16-0218