Honeywell 6820EVS Installation And Optimization Manual page 192

LS10144-001SK-E
stored in the desired slot, then you must erase the message first. (see Section 11.8.3).
5. Select the amplifier and circuit for the audio to play through during programming. A user would generally
pick the audio circuit that is in closest proximity to them.
6. Press EVS Message Key 1 to enter the message slot selection mode. Then, press the Select Key 1-15 that
corresponds to the message slot that you wish to record to. The associated Select Key red LED will begin
flashing, indicating that the message slot is ready for recording.
7. Press the push-to-talk (PTT) button on the microphone and speak your message.
8. Release the PTT button on the microphone to save your message. The Select Key green LED for this loca-
tion will turn on.
9. To playback the recorded message, press the Select Key 1-15 that was just recorded to.
10. If you are not satisfied with the recorded message, erase it (see Section 11.8.3) and then repeat steps 1
through 7.
Recording with Microphone Example:
User wants to record a message to message slot 5 via the microphone.
Upon entering the Local Recording mode via the keypad menu, the VCM will light the Select Key green LEDs
for 1-15 for each occupied message slot.
If a message already exists in message slot 5, it must first be erased. Press EVS Message key 8, then press Select
Key 5, (see Section 11.8.3). When the message has been erased Select Key 5's green LED will turn off.
To record a message, press EVS Message Key 1, press Select Key 5 (this will use message slot 5 for the
recording). Select Key 5's red LED will begin flashing.
Press the push-to-talk button on the microphone and speak your message. Release the PTT button to save your
message. Select Key 5's red LED stays on until processing is completed. Select Key 5's green LED comes on
after the recording is completed.
Pressing Select Key 5 will start a playback of the recorded message.
Press
Select Key 5
to record to
this message
slot
Figure 11-7 Recording with Microphone Example
Emergency Voice System Operation
11-14
Press
EVS Message
Key to enter
message slot
selection mode