Synchronize Strobes Active During Silence; Auto Display Event; Daylight Savings Options; Automatic Daylight Savings Adjustment - Honeywell 6820EVS Installation And Optimization Manual

LS10144-001SK-E

9.6.3.1 Synchronize Strobes Active During Silence

When "SYNC Strbs w/ Sil:" is Selected as Y (Yes) then strobes will continue to flash when the system is silenced
and will stop flashing when the system is reset.
Note: The "SYNC Strbs w/ Sil:" only functions with outputs that use a synchronized output pattern.
5. Press the up or down arrow to toggle this selection between Y (Yes) or N (No).
6. Press the right arrow
Note: See Section 9.6.3.1 for more information about Synchronization protocol choices.

9.6.3.2 Auto Display Event

When this feature is programmed Y (Yes) then the oldest un-acknowledge event will automatically display on
the control panel and remote annunciators after there has been no activity on any system touchpad for two
minutes.
7. Press the up or down arrow to toggle this selection between Y (Yes) or N (No).
8. Press the right arrow
9.6.4

Daylight Savings Options

To edit Daylight Savings:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Program Menu.
3. Select 5 for System Options.
4. Select 6 for Daylight Savings.

9.6.4.1 Automatic Daylight Savings Adjustment

The control panel has an automatic DST (Daylight Saving Time) adjustment feature. If this feature is not enabled
(set to No), the Daylight Saving Time change is not made to the system clock.
To enable or disable DST adjustment continue programming:
5. Select Y (enabled) or N (disabled) by pressing the up or down arrow, then press ENTER.

9.6.4.2 Daylight Saving Time Start and End

This option lets you to adjust the week and month Daylight Saving Time (DST) starts and ends. For this feature
to work, you must enable (set to Yes) the Automatic Daylight Savings Adjustment option under Daylight Savings
Options. The default values for the DST Start and End are:
DST Start: The second Sunday in March
DST End: The first Sunday in November
To set the start and end for Daylight Saving Time:
6. Press the up or down arrow to select the week (1st, 2nd, etc.) Daylight Saving Time starts, then press
ENTER to make your selection and move to the month setting.
7. Press the up or down arrow to select the month (January – December) Daylight Saving Time starts, then
press ENTER to make your selection and move to the DST End option.
8. Press the up or down arrow to select the week (1st, 2nd, etc.) Daylight Saving Time ends, then press ENTER
to make your selection and move to the month setting.
ENTER to make your selection and move to the next programming option.
or
ENTER to make your selection and move to the next programming option.
or
9-24
Programming