Logging Logfile - Cisco Nexus 3548 Command Reference Manual

System Management Commands

logging logfile

To configure the name of the log file used to store system messages and the minimum severity level to
log, use the logging logfile command. To disable logging to the log file, use the no form of this
command.
Syntax Description
logfile-name
severity-level
size bytes
Command Default None
Command Modes
Global configuration mode
Command History Release
5.0(3)A1(1)
Examples This example shows how to configure a log file called logfile to store system messages and set its
severity level to 4:
switch# configure terminal
switch(config)# logging logfile logfile 4
switch(config)#
OL-27851-02
logging logfile logfile-name severity-level [size bytes]
no logging logfile [logfile-name severity-level [size bytes]]]
Name of the log file to be used to store system messages.
Number of the desired severity level at which messages should be logged.
Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
•
•
•
•
•
•
•
•
(Optional) Specifies a maximum file size. The default file size is 4194304
bytes and can be configured from 4096 to 4194304 bytes.
Modification
This command was introduced.
Cisco Nexus 3548 Switch NX-OS System Management Command Reference
0—emergency: System unusable
1—alert: Immediate action needed
2—critical: Critical condition—default level
3—error: Error condition
4—warning: Warning condition
5—notification: Normal but significant condition
6—informational: Informational message only
7—debugging: Appears during debugging only
logging logfile
79