Cisco Nexus 3548 Command Reference Manual page 28

alert-group (Call Home)
alert-group (Call Home)
To configure a CLI show command for an alert group, use the alert-group command. To remove a CLI
command from an alert group, use the no form of this command.
Syntax Description
alert
user-def-cmd
CLI-command
Command Default None
Command Modes
Callhome configuration mode
Command History
Release
5.0(3)A1(1)
Usage Guidelines You can customize predefined alert groups to execute additional CLI show commands when specific
events occur and send that show output with the Call Home message. You can assign a maximum of five
user-defined CLI show commands to an alert group.
You must enclose the show command in double quotes. Only valid show commands are accepted.
Cisco Nexus 3548 Switch NX-OS System Management Command Reference
18
alert-group alert user-def-cmd CLI-command
no alert-group alert user-def-cmd CLI-command
Alert group. The alert group can be one of the following:
•
•
•
•
•
•
•
•
•
•
•
•
•
Specifies a CLI command for an alert group.
CLI show command. The command can be a maximum of 512 characters.
Modification
This command was introduced.
All—All alert groups
Cisco-TAC—Cisco TAC events
Configuration—Configuration events
Diagnostic—Diagnostic events
EEM—EEM events
Environmental—Power, fan, temperature-related events
Inventory—Inventory status events
License—Licensing events
Linecard-Hardware—Linecard-related events
Supervisor-Hardware—Supervisor-related events
Syslog-group-port—Syslog message events filed by port manager
System—Software-related events
Test—User-generated test events
System Management Commands
OL-27851-02