Logging Event Port - Cisco Nexus 3548 Command Reference Manual

logging event port

logging event port
To log events on an interface, use the logging event port command. To disable logging of interface
events, use the no form of this command.
Syntax Description
link-status
trunk-status
default
Command Default None
Command Modes
Interface configuration mode
Command History Release
5.0(3)A1(1)
Examples This example shows how to log interface events:
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# logging event port link-status default
switch(config-if)#
Related Commands Command
show interface
show logging
Cisco Nexus 3548 Switch NX-OS System Management Command Reference
76
logging event port {link-status | trunk-status} [default]
no logging event port {link-status | trunk-status}
Specifies to log all UP/DOWN and CHANGE messages.
Specifies to log all TRUNK status messages.
(Optional) Specifies the default logging configuration that is used by
interfaces not explicitly configured.
Modification
This command was introduced.
Description
Displays the interface configuration information.
Displays the logging status.
System Management Commands
OL-27851-02