Ptp Priority1 - Cisco Nexus 3548 Command Reference Manual

System Management Commands

ptp priority1

To configure the priority1 value when advertising the Precision Time Protocol (PTP) clock, use the ptp
priority1 command. To remove the priority1 value, use the no form of this command.
Syntax Description
priority-number
Command Default 255
Command Modes Global configuration mode
Command History Release
6.0(2)A1(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the priority1 value when advertising the PTP clock:
switch# configure terminal
switch(config)# ptp priority1 10
switch(config)#
This example shows how to remove the priority1 value when advertising the PTP clock:
switch# configure terminal
switch(config)# no ptp priority1 10
switch(config)#
Related Commands Command
feature ptp
ptp source
ptp domain
ptp priority2
show ptp brief
show ptp clock
OL-27851-02
ptp priority1 priority-number
no ptp priority1 priority-number
Priority number. The range is from 0 to 255.
Modification
This command was introduced.
Description
Enables or disables PTP on the switch.
Configures the source IP address for all PTP packets.
Configures the domain number to use for this clock.
Configures the priority2 value to use when advertising this clock.
Displays the PTP status.
Displays the properties of the local clock.
Cisco Nexus 3548 Switch NX-OS System Management Command Reference
ptp priority1
107