Danfoss VLT FC51 Design Manual page 30

Selection
Step 3
Place the bracket on the back of the LCP, then slide down.
Tighten screws and connect the cable to the LCP.
NOTICE
Use the provided thread cutting screws to fasten the
connector to the LCP. Tightening torque: 1.3 Nm.
4 4
Illustration 4.7 Place the Bracket on LCP
Illustration 4.8 Tighten Screws and Connect Cable to LCP
28
®
VLT Micro Drive FC 51 Design Guide
Step 4
Connect the cable to the frequency converter.
NOTICE
Use the provided thread cutting screws to fasten
connector to the frequency converter. Tightening torque:
1.3 Nm.
Illustration 4.9 Connect Cable to the Frequency Converter
MG02K302 - Rev. 2013-12-03