Switching Authorized Reception On/Off; Selecting Whether To Exclude Or Include Senders - Ricoh 170 / 180 Operator's Manual

The number of RTI/CSI's that you can store for use with this feature and the
forwarding feature is limited to 30 for Type I Models and 10 Type II Models.
However, you can use Wild Cards to extend the number of RTI/CSI's that you can
specify.
NOTE: If you turn Authorized Reception on and you do not program any
senders's RTI's / CSI's, your machine will not able to accept any
messages. If one of the authorized terminals changes their RTI/CSI,
you have to change the stored RTI also. Otherwise, you will not be
able to accept messages from that sender any more.
Cross-references
RTI and CSI: see pages 18 and 20.

Switching Authorized Reception On/Off

Before you use Authorized Reception, you have to switch it on using Function 62.
If it is switched off, the machine will accept any incoming fax message.
1. Press the Function key and
6,2,2,2,2,6,2 using the ten keypad. Then
press the Yes key.
2. Press the key until "
k
" is displayed.
3. Press the Yes key.
4. Use the and the
j
feature on or off.
5. Press the Yes key to store your setting,
then press the Function key.

Selecting Whether to Exclude or Include Senders

1. Press the Function key and
6,2,2,2,2,6,3 using the ten key-pad,
then press the Yes key.
2. Press the Yes key, then press the
until the settings for switch 08 are dis-
played.
keys to switch this
k
key
k
TCR: see page 85.
k
k
j
RECEPTION
k
k
j k
j k
j k
j k
67