Installing The Machine; Location; Installation - Ricoh 170 / 180 Operator's Manual

Ricoh operator manual fax 170 / 180
Table of Contents

Advertisement

INSTALLING THE MACHINE

LOCATION

For the best possible performance, install your machine in a place which satisfies
the following conditions.
Not exposed to direct sunlight
Well ventilated (air turnover at least three times per
hour).
Level
Not subject to vibration
Away from other electronic equipment, to avoid
interference
Away from areas containing corrosive gas.
Dust-free
Condensation-free
Temperature 17 to 28°C[63 to 82 °F]
Humidity 40 to 70%RH (do not install near a
humidifier)
Away from heaters and air conditioners, to avoid
sudden changes of temperature
Within 2m (2.2 yards) of a three-pin grounded power outlet
With the clearance as shown on the right
NOTE: If you wish to receive legal size messages or copy the legal size docu-
ments, you must allow 8" (20cm) clearance at the back of the machine.

INSTALLATION

CAUTION:Do not plug it in until everything is connected properly.
When moving the machine, first disconnect the telephone line, then the power
cord.
NOTE : Before doing the installation procedure, check the contents of the box . In
some models, some of the accessories have already been installed.
Fax Machine
Paper Roll
Document Table
Copy tray
Operation Manual
Handset
Telephone Cord
Quick Dial Sheet
Modular Cord
Paper Guide
Paper Holder Rod
8" (20cm)
4" (10cm)
4" (10cm)
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fax170Fax180

Table of Contents